1. There are several reasons why electromagnetic flowmeters may not have a flow signal output:
One is that the cable between the excitation system and the signal system is not connected; the second is that the flow direction of the monitoring liquid does not coincide with the direction of the arrow on the sensor housing; third, the liquid in the pipeline is not filled; and the fourth is the electromagnetic flow meter Causes the excitation coil to burn out.
The corresponding solution is as follows:
The first is to check the cable interface and connect it; the second is to change the direction of installation of the sensor; the third is to install a U-shaped pipe on the downstream side of the electromagnetic flow; fourth is to discharge the electromagnetic flowmeter water in time, if not serious, you can Dry the terminals and continue to use them; if burned out, replace the new excitation coils.
2. There are several reasons why the measured value of the flow rate of the electromagnetic flowmeter may not match the reference value provided by the electromagnetic flowmeter:
One is that the resistance between the two poles of the sensor has changed or the insulation of the two poles has been reduced; the second is that the liquid in the pipeline has bubbles or liquid filling dissatisfaction; the third is that the set value of the start of the converter is wrong.
The corresponding solution is as follows:
One is to replace the sensor; the other is to check the existence of the fluid, so that the fluid fills the entire pipe; the third is to check the constant of the electromagnetic flowmeter and the unit of measurement, pipe diameter and other values, and accurately adjust the zero point and range of the converter.
3. The electromagnetic flowmeter output signal may exceed the full-scale value due to the following reasons:
One is that the excitation system and signal system cables are not connected; the second is that the converter's instrument constants and parameters do not match; and the third is a lightning strike.
The corresponding solution is as follows:
One is to inspect the cable interface and connect it; the other is to enable the backup circuit board to inspect the components of the converter. If damage is found, replace it in time and replace it. The third is to set lightning protection measures for the power line.
CNC End Mill Cutting Tools Tungsten Carbide Twist Drill Bit
Solid Carbide Milling Cutter CNC End Mill Cutting Tools
Product Description
Model Number:Standard Size
Type:Twist Drill Bit
Use:Metal Drilling
Finish:Other, Plain
Precision:High Precision
Processing Type:Metal Milling
Suitable For:Copper, Cast Iron, Carbon Steel,Mold Steel,Tool Steel
Machine Type:Milling Machine
HRC:HRC45/55/60/65
Usage:General purpose/High speed cutting
Auto:Automatic
Controlling Mode:CNC
Transport:Air/courier/maritime
Coating:TiAlN/AlTiN
Certification:GS
Carbide end mill cutters advantage:
1. 100% Virgin raw material
2. With production experience over 10 years
3. Advanced production equipment
4. The cutter is a tool equipment with a stronger hardness and longer-life to use which is widely used in the line of machinery like the CNC lathe,has a quite strong hardness to work and it can speed the application of machinery and enhance the efficiency.
4.Industry Standard Corner Radii
5.Super Coating
2.Applications
Carbide Variable flute end mill
1.Suitable for Copper, Cast Iron, Carbon steel, Tool steel, Mould steel, Die steel, Stainless steel, Plastic, Arcylic, etc.
2.Applicated for Aerospace, transportation, Medical equipment, military manufacturing, mould development, apparatus and instrument, etc
CNC End Mill Cutting Tools Tungsten Carbide Twist Drill Bit,SOLID CARBIDE TWIST DRIL,Solid Carbide Milling Cutter,CNC End Mill Cutting Tools
Changzhou Bomitools Co.,Ltd. , https://www.bomitools.com