How to install the wing gate of campus community?

The installation of campus community wing gates is actually very easy for engineering personnel. Today, we will explain in detail the specific steps for installing campus community wing gates, mainly for reference by non-professionals, such as some engineering companies and integrators.

This can be done by installing a wing gate in a campus community. There are three main steps: pre-embedding, wing gate fixing, and wiring.

Step: First install the wing gate of the community to carry out road embedding

Excavate cable trenches-Control cables and power cables pass through the cable ducts and put into the cable trenches. A connecting cable should also be reserved between two wing gates (including single-core wing gates and dual-core wing gates) in one channel , The concrete pre-buried line trench after laying the line

Step 2: Fix the wing gate of the community

After the function of the wing gate is successfully debugged, the chassis must be fixed at the specified position with expansion screws (if it is a marble floor, it must be glued)

Before powering on, you should carefully check whether the terminals of the main board of the pedestrian access wing gate are loose, ensure that the mechanical parts are not stuck, operate flexibly, whether the equipment is reliably grounded, and whether there is a short circuit phenomenon, etc.

Step 3: Wiring of the community wing gate controller

According to the wiring diagram of the pedestrian wing gate on the specific instructions of the wing gate of the gate manufacturer, the professional engineer should connect the output signal lines of the wing gate control system and other matching systems separately according to the pedestrian wing gate wiring principle.

After knowing how to install the pedestrian wing gates, more questions about the selection and price of pedestrian wing gates can be made online at any time.